4100ES-S1 Programming Guide Document: LT0400
Introduction
iv
11 BUILDING AND DOWNLOADING THE CONFIGURATION 11-1
11.1 BUILDING THE JOB 11-2
11.2 IP FILE TRANSFER UTILITY / CONNECTION TO THE PC 11-3
11.2.1 IP FILE TRANSFER 11-3
11.2.2 CONNECTION TO THE PC 11-3
11.3 STARTING THE IP FILE TRANSFER UTILITY 11-3
11.4 IP COMMUNICATION PARAMETER SETTINGS 11-4
11.5 IP FILE TRANSFER 11-4
11.5.1 DOWNLOAD TAB 11-4
11.5.2 ADDITIONAL DOWNLOAD TAB FUNCTIONS 11-6
11.5.3 UPLOAD/REPORTS TAB 11-6
11.5.4 MASS STORAGE TAB 11-8
11.5.5 HISTORY/UNDO TAB 11-9
11.6 SERIAL FILE TRANSFER (4100U AND OLDER SYSTEMS) 11-10
11.6.1 STARTING THE SERIAL TRANSFER UTILITY 11-10
11.6.2 SERIAL COMMUNICATION PARAMETER SETTINGS 11-11
11.6.3 DIRECT CONNECTION TO THE PANEL 11-11
11.6.4 DOWNLOADING THE CFIG FILE 11-12
11.6.5 UPLOADING FROM THE PANEL (SERIAL) 11-13
11.7 SENDING 4100ES-S1 FILES TO TFPP/SIMPLEX. 11-13
12 APPENDICES 12-1
12.1 APPENDIX A – AS4428.1 OPERATION 12-2
12.2 APPENDIX B - COMMON VARIABLES AND CUSTOM CONTROL 12-3
12.2.1 DIGITAL PSEUDO POINTS 12-3
12.2.2 ANALOG POINTS 12-4
12.2.3 LISTS 12-4
12.2.4 PHYSICAL HARDWARE POINTS (LEDS RELAYS ETC) 12-4
12.2.5 BATTERY TEST 12-5
12.2.6 ALARM VERIFICATION TIMING AND START UP SETTINGS 12-5
12.2.7 BRIGADE RELAY EQUATIONS 12-6
12.3 APPENDIX C - CUSTOM CONTROL FOR CONTROL KEYS & INDICATORS 12-8
12.3.1 COMMON ZONE ALARM LED 12-9
12.3.2 ALARM / FAULT / NORMAL TEST BUTTON AND LEDS 12-10
12.3.3 EXAMPLE ALARM AND FAULT TEST EQUATIONS 12-12
12.3.4 A/C RESET BUTTON AND A/C TRIP LED 12-12
12.3.5 BELLS ISOLATE LED AND BUTTON 12-13
12.3.6 WARNING SYSTEM ISOLATE 12-14
12.3.7 CLEAN UP EQUATIONS 12-14
12.4 APPENDIX D - CUSTOM CONTROL FOR ALARM ZONE FACILITIES 12-16
12.4.1 DIGITAL POINTS USED 12-16
12.4.2 LISTS 12-17
12.4.3 SWITCHES AND LEDS 12-17
12.4.4 ZONE 1 EQUATIONS 12-17
12.4.5 ZONE N EQUATIONS 12-18
12.5 APPENDIX E - 4100-1282 AZF SWITCH AND LED ADDRESS MAPPING 12-20
12.6 APPENDIX F – USEFUL PSEUDO POINTS AND LISTS 12-22
To Next Page
Loading...
Need help?
General
