3-6
Figure 3-6. System Reset Window
2. At the System Reset Window, press System Reset or Priority 2 Reset and the
system is reset. You can also reset the system by pressing the membrane key
again.
If you change your mind and decide that you do not want to reset the system,
press Cancel and you are returned to the Active List Screen.
The Disable/Enable function allows you to disable or enable a point on the
active list. To enable a point on the active list do the following:
1. At the Active List Screen, press Disable/Enable at the bottom of the screen.
The options at the bottom of the screen change to show Return, Disable
Point, and Enable Point as shown in (Figure 3-7).
Continued on next page
Viewing Active Lists, Continued
Resetting the System
(Continued)
Disabling/Enabling Points
To Next Page
Loading...
