EA180 Servo Drive Manual
86
Parameter function: when PA-00=4 , this parameter is used to select the segments to be executed.
When this parameter is set to nonzero, the specified segment speed is executed immediately. For example, when the parameter is
changed to 8, then run right away at speed PA-17 of segment , when this parameter is 0, stop and waiting for next command.
Here below is description of two parameters in association with spd1, parameters in other groups follow to the same.
Multi-speed command spd1 running speed
Parameter function: first segment speed of multi preset speed.
Multi-step speed command spd1 running time
Parameter function: when selecting cyclic operation (PA-00=0, 1, 2), the running time for the first preset speed operation.
This parameter is invalid when PA-00=3 or 4.
Running time of multi-speed command Spd2
Running time of multi-speed command Spd3
Running time of multi-speed command Spd4
Running time of multi-speed command Spd5
Running time of multi-speed command Spd6
Running time of multi-speed command Spd7
Running time of multi-speed command Spd8
Running time of multi-speed command Spd9
Multi-speed command Spd10
Running time of multi-speed command Spd10
Multi-speed command Spd11
Running time of multi-speed command Spd11
Multi-speed command Spd12
Running time of multi-speed command Spd12
Multi-speed command Spd13
Running time of multi-speed command Spd13
Multi-speed command Spd14
Running time of multi-speed command Spd14
Multi-speed command Spd15
Running time of multi-speed command Spd15
Multi-speed command Spd16
Running time of multi-speed command Spd16
To Next Page
Loading...
Need help?
General
