78 MN.00356.E - 003
11 RADIO LINK LINE-UP
11.1 GENERAL
The radio link setup is made up by:
• radio configurator
• modulation & capacity setting
• link ID setting
• frequency setting
•Tx power setting (no ATPC)
• Tx power setting (ATPC)
All these operations are achieved via WEBLCT. In following paragraphs these operations are explained.
11.2 RADIO CONFIGURATOR
In WEBLCT select Equipment menu, Radio Configurator.
If the Link configuration present in Current Radio Configuration card is correct, go to next paragraph if not
delete it.
11.2.1 Delete a Link in Current Radio Configuration
• Select Delete a Link and push Next
• Select the Link to delete and push Done
Now the current Radio Configuration is empty.
11.2.2 Create a Link in Current Radio Configuration
• Select Create New Link and push Next
• Proceed as in fig. NEW LINK. In Select Link Type menu select the desired configuration and, in Avail-
able Radio list, the Radio to use (one in case of 1+0, 2 in case of 2+0 XPIC). Push Done.
To Next Page
Loading...