Need help?Do you have a question about the SM ALFOplus2 and is the answer not in the manual?
Declaration of conformity for the ALFOplus2 Digital Radio Relay System.
Provides first aid procedures for electrical shock and general safety rules.
Explains the manual's purpose, intended audience, and overall structure.
Provides a glossary of acronyms used throughout the handbook.
Details the general features, characteristics, and applications of the ALFOplus2 system.
Describes various radio link configurations for single and dual equipment.
Outlines the implemented radio functionalities of the ALFOplus2.
Details the supported Ethernet switch functionalities and features.
Lists the security protocols implemented in the ALFOplus2.
Describes management capabilities, including InBand and OutOfBand options.
Explains the adaptive modulation algorithm and its benefits for link gain.
Details the characteristics of Ethernet electrical and optical interfaces.
Describes the available local and remote loop facilities for operation checks.
Information on power supply options and cable specifications.
Specifies operational temperature, humidity, and wind resistance parameters.
General information and procedures for installing the ALFOplus2 equipment.
Details on how to perform grounding connections for the ODU and system.
Procedure for assembling the ODU with the correct antenna interface module.
Steps for installing the ODU using a single rectangular output flange.
Procedure for installing the ODU with an OMT output flange.
Instructions for installing the ODU using a dual output flange.
Describes the M12 and RJ45 connectors for system connection and management.
Lists necessary accessories for the installation of the ALFOplus2 system.
Overview of the steps involved in setting up the ALFOplus2 radio link.
Details on connecting the ALFOplus2 for line-up via WEBLCT or CLI.
Configuring the ALFOplus2 in Customer, Provider, or Provider Edge Bridge mode.
Describes management plane configurations and port participation.
Configuration steps for Out of Band management via WEBLCT or CLI.
Configuration steps for In Band management via WEBLCT or CLI.
Overview of the radio link setup process using WEBLCT.
Procedure for configuring radio links, including creation and deletion.
Setting modulation profiles, bandwidth, and capacity parameters.
Configuration of the local and remote link ID for link identification.
Procedure for setting radio branch frequencies and duplex spacing.
Configuration of ODU transmit power, including manual and ATPC modes.
Guide to optimizing antenna alignment using RX signal power measurements.
Introduction to traffic port configuration examples using LAN1 and LAN2.
Configuration examples for Customer Bridge mode traffic.
Configuration examples for Provider Core Bridge mode traffic.
Configuration examples for Provider Edge Bridge mode traffic.
Measures for verifying Ethernet performance before link commissioning.
Procedure for updating the ALFOplus2 equipment firmware.
Instructions for backing up and restoring the system configuration.
Description of the alarm system, severity levels, and alarm groups.
Procedures for routine maintenance and troubleshooting of the equipment.
Overview of programming and supervision methods using CLI, WebLCT, or NMS.
Details on management plane configuration for supervision.
Procedure for compiling and executing scripts via CLI commands.
Details on the composition and versions of the outdoor unit.
Information on ODU part numbers and associated identifiers.
General overview of ALFOplus2 characteristics common to all versions.
Specific characteristics and standards for the 11 GHz version.
Specific characteristics and standards for the 18 GHz version.
Specific characteristics and standards for the 23 GHz version.
Specific characteristics and standards for the 25 GHz version.
An index of all figures included in the user manual.
An index of all tables included in the user manual.
Information on how to obtain further assistance and support.
To Next Page
General