84 MN.00356.E - 003
12 ETHERNET TRAFFIC CONFIGURATION
12.1 GENERAL
Some examples of traffic port configuration are suggested in the following paragraphs using two ports only,
LAN1 and LAN2 on local and remote unit.
Other ports can be used following the same procedures here shown.
Three main configurations “pipe” are suggested depending on traffic kind and Bridge mode:
• CB for untagged traffic and known C-tagged traffic
• PCB for known S-tagged traffic
• PEB for untagged traffic and unknown C-tagged traffic.
Suggested configurations are with In Band management where both the LAN1 and LAN2 ports are used for
traffic and management.
In case of Out of Band management only LAN1 port can be used for traffic and so in the following examples
all the commands referred to LAN2 port (second pipe) have to be avoided.
Pipe 1: Local LAN1 port <--> Remote LAN1 port
Pipe 2: Local LAN2 port <--> Remote LAN2 port
The two pipes contain segregated traffic.
To Next Page
Loading...