SMC Networks HRS012-A-10 Series - Page 157

HRX-MM-N007
Chapter 4 Service Procedure
HRS Series 4.5 Replacement Procedure
4-21
5. Remove the cable from the condenser.
6. Remove the ground cable(G4) attached to the pump. (Screw ×1)
For the HRS030, cut the cable tie of the pump cable fixed to the fan motor bracket.
7. Remove the hose attached to the pump. (2 pcs.)
8. Remove the condenser. (Screw ×1)
9. Remove the pump. (Screw ×4)
Fig. 4.5-6 Removal of high pressure pump
 Mounting
1. Mount the cap and bracket to the condenser,and it mount the electrical equipment panel.
(Screw ×1)
Fig. 4.5-7 Mount the condenser
Condenser
Condenser bracket
Condenser cap
5 ． Removal of condenser cable
4 ． Removal
connector
9 ． Removal pump
6 ． Ground cable
3 ． Support panel
8 ． Removal of condenser
Screw
7 ． Removal
of hose
[For HRS030]
Fan motor
bracket
7 ． Cable tie