Paramount ME User’s Guide
64
Save to Flash
When changes are made to the values on the Setup tab, they will remain active until the
mount is powered down unless you click the Save in Flash button. Note that while the
values are saved into flash memory, the motors are stopped. This does not mean that
position information is lost, just that the telescope will stop tracking at the sidereal rate
momentarily (approximately one-half second).
Copy to Clipboard
Click this button to copy the control system parameters report to the Windows Clipboard.
To view this text, click the Paste command from the Edit menu of any text editor, such as
Notepad. You may be asked to email this information to Software Bisque if there is an
issue with the control system. Following is a sample of the information that is copied to
the clipboard when this command is used. The comments after the “//”on the right were
added by the author.
Software Bisque strongly recommends that you print and save a copy of these parameters
for your mount.
Bisque Telescope Control System (TCS) Copyright 2002-2005 Software Bisque, Inc.
Mount Id.: Paramount ME Running at: 3333.333
***************** Axis 0 (RA) Control version: 2.5.19 *****************
Index angle: 1989 // Mount dependent number
Base rate: -43067265
Maximum speed: 1080000000
Acceleration: 400
Non-sidereal tracking rate: 0
Minimum position limit: -4960000
Maximum position limit: 1120000
Sensor HA (from sync): 2.0000
Guide: -672926
Tics per revolution: 11520000
PEC ratio: 10
Maximum position error: 1000
Unit Id.: 100
EMF constant: 72
Home velocity high: 660000000
Home velocity medium: 110000000
Home velocity low: 3900000
Home direction, sense: 1100
Home mode, required, Joystick, In-out-in: 2111
Home index offset: 0 // Mount dependent number
PEC cutoff speed: 0
Maximum voltage: 15
Maximum gain: 150
***************** Axis 1 (Dec) Control version: 2.5.19 *****************
Index angle: 333 // Mount dependent number
Base rate: 0
Maximum speed: 1080000000
Acceleration: 400
Non-sidereal tracking rate: 0
Minimum position limit: -5460000
Maximum position limit: 1700000
Sensor Dec (from sync): 0.0000
Guide: 438102
Tics per revolution: -7500000
PEC ratio: 10
Maximum position error: 1000
Unit Id.: 100
EMF constant: 72
Home velocity high: 660000000
Home velocity medium: 110000000
Home velocity low: 3900000
Home direction, sense: 1100
Home mode, required, Joystick, In-out-in: 2111
Home index offset: 0 // Mount dependent number