39
4 Preparation before Installation
4.1 Selection of Installation Location
The installation location selected for the devices of X3-IES system is quite critical in the
aspect of the guarantee of machine safety, service life and performance.
• It has the IP66 ingress protection, which allows it to be installed outdoor;
• The installation position shall be convenient for wiring connection, operation and
maintenance.
4.1.1 Environment Requirement
Make sure the installation site meets the following conditions:
• The operating temperature: -30
℃
to +53
℃
;
• The humidity shall be between 5-95%;
• Do not install the devices in the areas where the altitude exceeds 3000 m;
• Install the devices in a well-ventilated environment for heat dissipation;
• Do not install the devices in areas with flammable, explosive and corrosive
materials;
• Do not install the devices in areas near combustibles and antenna
• You are recommended to install an awning over it. Direct sunlight, rain exposure
and snow laying up is not allowed.
-30
℃
-+53
℃
No direct sunlight No rain exposure No snow lay up
Rain exposureNear combustibles Direct sunlight Snow lay up Near antenna
IP66
5-95%RH
To Next Page
Loading...
Need help?
General
