To Next PageTo Next Page
Need help?Do you have a question about the Spectra-Physics InSight X3 and is the answer not in the manual?
Manual contains information to safely operate the InSight X3 laser system.
Outlines the sections of the user's manual, including Introduction, Safety, Controls, etc.
Information regarding electrical service requirements for the equipment.
Conditions under which the laser system functions are listed.
Compliance with FCC rules for Class A digital devices.
Symbols used to draw attention to important situations/procedures.
Explains symbols like "Do not touch", "Eyewear Required", "Serviceable only by factory trained personnel".
Lists units and their abbreviations used in the manual.
Describes the InSight X3 laser system, its features and components.
Information regarding patents related to the system.
Lists optical, mechanical, and environmental specifications.
Illustrates measured performance of wavelength tuning.
Provides dimensioned drawings of the laser head and power supply.
Review safety information before unpacking, setup, or operating.
Precautions for handling Class IV lasers to prevent injury.
Describes emission indicators, connectors, and interlocks.
Functions needed to satisfy CDRH regulations for embedded systems.
Procedures to maintain compliance with CDRH regulations.
Displays and explains warning labels on the equipment.
Translations of safety labels for non-English speakers.
Information about the WEEE symbol and recycling.
Declaration of conformity to EU directives.
Lists organizations and standards for laser safety.
Describes controls, indicators, and connections of the system.
Details rear panel controls, indicators, and connectors of the laser head.
Details controls and connections of the power supply.
Describes RS-232, Emission, and Interlock connectors.
Refers to chiller manual for controls and operation.
Instructions for inspecting shipping containers upon receipt.
Summarizes how the system is packaged.
Instructions if damage is apparent.
Instructions for repacking system for service or return.
States installation is by a Spectra-Physics service engineer.
Lists requirements for the installation site.
Specifies chiller requirements for coolant.
Instructions for installing GUI control software.
Describes the DeepSee component for dispersion compensation.
Information on operating the chiller.
Guides on using the GUI software.
Step-by-step guide to turn on the laser system.
Steps to turn off the laser system.
Modify and create objective tables.
Provides operating info and specialized modes.
Explains laser head requires no routine maintenance.
Provides tips for maintaining the chiller.
Procedure to clean the mesh filter from the chiller water filter.
Section for diagnosing system issues.
Assists in isolating problems with the laser system.
Lists field replaceable units and their part numbers.
Details the warranty terms for the laser system.
Instructions for requesting laser service.
Lists Spectra-Physics service centers.
Explains SCPI protocol and command rules.
Lists commands and queries with page references.
Returns status byte for component status.
Commands related to the DeepSee component.
How to use RS-232 and USB ports for control.
Lists status codes and messages from the laser system.
Discusses the process of generating short laser pulses.
Explains how wavelength affects light velocity in materials.
MSDS for algaecide used in chiller.
MSDS for cleaner used in chiller.
General| Pulse Width | <120 fs |
|---|---|
| Repetition Rate | 80 MHz |
| Beam Divergence | <1.5 mrad |
| Wavelength Range | 680 - 1300 nm |
| Output Coupling | Free-space |
| Polarization | Linear |
| Weight | 23 kg |
