5-1
CHAPTER 5: Installation
System Installation
A Spectra-Physics service engineer will install your InSight
®
X3
™
laser system. Do NOT
install it yourself.
Site Considerations
This chapter assumes that you have already inspected the shipping crates (and contents
if instructed to do so) for damage upon receiving the system (refer to
Chapter 4,
“Receiving and Inspecting”). It also assumes that the system has been carefully
unpacked by a Spectra-Physics service engineer, and that the system is now at the
installation site.
This chapter does NOT provide typical installation instructions for the InSight X3 laser
system. A Spectra-Physics service representative will install the system as part of your
purchase agreement.
System Installation Considerations
A Spectra-Physics service engineer will install your InSight X3 laser system. While
operating the system, be sure to follow all safety precautions listed in
Chapter 2, “Laser
Safety and Compliance.” Verify that all laser safety devices are in place before using the
laser.
All InSight X3 systems are initially installed by Spectra-Physics
as part of the purchase agreement. Relocating an InSight
X3
system after installation requires a service call to
Spectra-Physics. An InSight
X3 system can only be moved by
an authorized Spectra-Physics service representative who is
trained in this procedure.
The IPS-300 power supply, laser head, and chiller are heavy! If
you must move them, ask for help. Do not attempt to move
these items by yourself.
Personal injury and product impairment can occur if this
product is used in a manner not specified by the manufacturer.
Misuse voids warranty.
To Next Page
Loading...
