Installing the Control Software
Installation 5-5
This completes the installation of the USB driver software.
Installing the GUI Control Software
This section describes how to install the supplied GUI control software. As mentioned
earlier, your Spectra-Physics service representative will do this for you when they install
the system. The instructions below are provided in the event a different computer is used
and the software must be installed again.
1. .If you have not already done so, place the USB flash drive in a spare USB port.
Double-click
Setup.exe and follow any prompts that appear during installation.
The software creates the folder
C:\Program Files\Spectra-Physics\InSight X3 and installs itself in this
location (you can select the drive location; the default drive is C). It also installs
run-time components into the
C:\windows\system directory.
Finally, the software places an InSight X3 icon on the desktop and in the Start menu
under the
Spectra-Physics folder.
When you are ready to start operation, double-click the icon on the desktop or in the
Start menu to start the control software.
This completes the installation of the GUI control software.
To Next Page
Loading...
