v
Environmental Specifications
CE Electrical Equipment Requirements
For information regarding the equipment needed to provide the electrical service listed
under “Mechanical/Electrical Requirements” at the end of
Chapter 1, refer to
specification IEC 60309, “Plug, Outlet and Socket Couplers for Industrial Uses,” listed
in the official Journal of the European Communities.
Environmental Specifications
The environmental conditions under which the laser system functions are listed below.
These specifications reflect indoor use conditions.
FCC Regulations
This equipment has been tested and found to comply with the limits for a Class A digital
device pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, can cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the
user is required to correct the interference at their own expense.
Table 1-1 Laser head environmental specifications
Feature Specification
Altitude Up to 2000 m
Temperature, operating 20°C to 25°C
Relative humidity, operating Maximum 75% noncondensing up to 25°C
Temperature, storage 15°C to 30°C
Relative humidity, storage <65% for 15°C to 35°C
Cooled water temperature in closed-loop chiller 21°C typical
1
1. Avoid obstructing the air exhaust grills which will result in the recirculation of hot exhaust air. Cooling air
enters through the front panel and exits through the rear fan apertures.
To Next Page
Loading...
