General Operation Installation & Configuration Guide for MAXPage
1. To add or edit a group, press to choose Add/Edit Group from the Group Menu. The following screen
displays:
ID[ ]
Rotary[ ]
2. Enter the Group ID for the group using the keypad.
3. Press the key to move along to the next field. If the Group ID is being used by a pager, MAXPage
displays ID Used by Pager. If the Group ID is a group that already exists in the database, the details for
that ID are displayed in the fields. If the Group ID is not in the database, all fields are empty and are ready
for data entry.
NOTE: A Group ID is a reference number that identifies a group in the database.
ID[1 ]
Rotary [ ]
4. The next field is Rotary. Using the keypad, choose between Y or N (Yes or No).
a. Select Y to enable the rotary function. The rotary function is a special mode whereby when a message
is sent to the group, one user at a time receives a message. For example if there are three recipients in a
group and a message is sent to the it, only the first pager in the group will get the first message. The
next message that is sent to the group will go to the second pager and the third message sent will go to
the third pager in the group. If a fourth message is sent to the group, the cycle repeats.
b. If N is selected, all recipients within the group receive the message at the same time. Once you have
entered the required option, press the key to move to the next screen.
5. The first field on the next screen is Add. Type the Pager ID of a pager (or Group ID) you wish to add to this
group. You may need to press the key to enter the Pager ID if it is short. When the Pager ID has been
entered the screen shows ID added. If the Pager ID is in the group already, the screen shows ID already
included. More pagers or groups can be added by typing their ID in the Add field followed by the
key if required.
NOTE: Voice pagers (Two Tone & Group Tone) cannot be added to groups. If you wish to have a group of voice
pagers, create a new pager with the Receiver Type set to Group Tone and enter the common Group Tone for the
group of voice pagers into the cap code field.
Add[ ]Tot[ ]
Del[ ]
NOTE: The Tot field refers to the total number of ID’s within the current group.
6. Press the key to move along to the Del field. By pressing the key you can scroll through the Pager
ID’s of pagers in the group.
7. If you wish to save the group, press the key and the screen shows Group saved.
8. If you wish to remove a Pager ID from the group, scroll through until the Pager ID is found then press the
key. The screen below is shown.
ID[1 ] remove
from group?
To Next Page
Loading...