Instruction Manual
for
AS380 Series Elevator Integrated Drive Controller
36
staff can monitor the elevator position, running direction and fault condition and etc.
9 earthquake response function
Activate the earthquake function. if earthquake occur, the earthquake inspection device activated.
A contact signal from the device will be transferred to the control system. The control system will
instruct the running elevator to park at nearest floor and open the doors for passenger evacuation
as well as stop the elevator then.
10 car arrival gong
The Up/Down arrival gong installed at the top, bottom of the car will ring as the elevator
decelerate and level, alarming the passenger in car and hall that the elevator is leveling and about
to arrive.
11 arrival lamp at landing
Activate the function. The up/down arrival lamp installed at the hall of each floor will inform
passengers the upcoming arrival of the elevator.
12 arrival gong at landing
Activate the function. The up/down arrival gong at hall of each floor will inform passengers the
upcoming arrival of the elevator.
13 independent control of front and rear door
Passenger can make independent control of the front and rear door according to their own needs.
14 VIP priority service
A special service for the VIP passengers, the function enables the VIP passenger to arrival the
destination floor at fastest speed.
15 Emergency leveling when blackout
The building blackout causes the running elevator fail to reach the door zone and entrapment
occurs as the consequence. Under the above circumstance does the blackout emergency leveling
device activated. The elevator will be pushed at the low speed to the nearest door zone for
passenger evacuation.
16 service floor change-over by the switch control
Use the in-car switch to change the elevator service floor.
17 broadcasting function for upcoming floor
When install the floor broadcasting function to the system, the floor broadcaster will report the
upcoming floor during the leveling process and report the subsequent running direction of the
elevator at each time of door-closing.
18 weighing compensation
The load compensation value is given based on the car load data inspected by the weighing device.
In this way the elevator startup comfort will be improved.
19 door-opening holding buttons
Use the door holding button to enable the door-closing delay
20 out of service display
A display method to inform passenger that elevator is out of service.
21 IC card floor service control in car
Once this function is installed, a card reader is installed in the operating panel. Passenger must use
the card to register the instruction for authorized floors
22 IC card elevator call service control at hall
Once this function is installed, a card reader is installed at the call panel of each floor. Passenger
To Next Page
Loading...
Need help?
General
