Instruction Manual
for
AS380 Series Elevator Integrated Drive Controller
38
Chapter four: Wiring of Elevator Integrated Drive Controller
This chapter defines the wiring of elevator integrated drive controller terminals, including the
wiring of main circuit terminals, control circuit terminals and PG card terminals.
Danger
◎ Before wiring, please make sure that power supply is
completely disconnected.
Or it may cause risk of electric shock.
◎ Wiring must be performed by professional electrical
personnel.
Or it may cause risk of electric shock.
◎ Earth terminal E shall be grounded reliably.
Or it may cause risk of electric shock.
◎ Please never touch the terminal with hands; never have
the drive controller output line contact the enclosure.
Or it may cause risk of electric shock.
◎ Please never connect the power supply to output
terminals U, V and W.
Or it may cause damage.
◎ Please never short the terminal ○＋1/ ○＋2 with ○－.
Or it may cause risk of explosion.
◎ Please check the voltage of AC main circuit power
supply is consistent with the rated voltage of integrated
driver controller.
Or it may cause risk of fire and physical injury.
◎ Please correctly connect the braking resistor as per the
wiring diagram.
Or it may cause risk of fire.
◎ Main circuit terminal must be firmly connected with the
conductor or wire crimping terminal.
Or it may cause risk of damage.
Caution
To Next Page
Loading...
Need help?
General
