129
DEFRNLIT EN
0478 131 9965 A - EN
Install the cover. (Ö 9.2)
Press the OK button.
Connect the power supply unit plug
to the mains, then press the OK
button.
When the perimeter wire is correctly
installed and the docking station is
connected to the mains power supply, the
LED (1) illuminates.
Lift the robotic mower slightly by the
carrying handle (1) to relieve the weight on
the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
Then press the OK button on the
display.
9.11 Linking the robotic mower and
docking station
Checking the wire signal may take several
minutes. The red STOP button on top of
the machine terminates the link, the
previous installation assistant step is
called up.
Note the "Docking station controls"
section, particularly if the LED does
not illuminate as described. (Ö 9.2)
If the battery is discharged, a
plug symbol appears instead
of the battery symbol at the
top right corner of the display after
docking and the battery is charged
while the perimeter wire is being
routed. (Ö 15.7)
The robotic mower can only be
operated if it correctly receives the
wire signal emitted by the docking
station. (Ö 11.16)
To Next Page
Loading...
