Stihl RMI 522.0 C - Page 177

175
DEFRNLIT EN
0478 131 9965 A - EN
Message:
2075 – GPS signal
No reception in desired zone
Possible cause:
– The desired zone is in a dead spot
Remedy:
– Redefine the desired zone (Ö 10.)
Message:
2076 – GPS signal
Desired zone not found
Possible cause:
– The desired zone could not be found
during edge following
Remedy:
– Redefine the desired zone. Make sure
that the desired zone and perimeter
wire overlap (Ö 10.)
Message:
2077 – Desired zone
Desired zone outside home area
Possible cause:
– The desired zone is outside the stored
home area
Remedy:
– Redefine the desired zone (Ö 10.)
Message:
2090 – Radio module
Contact your specialist dealer
Possible cause:
– Communication with the radio module
interrupted
Remedy:
– No action required, firmware will be
automatically updated if necessary
– Contact your STIHL specialist dealer if
the problem persists
Message:
2100 – GPS protect.
Outside home area
Machine disabled
Possible cause:
– Robotic mower was removed from
home area
Remedy:
– Return robotic mower to home area and
enter PIN code (Ö 5.9)
Message:
2110 – GPS protect.
New location
New installation req.
Possible cause:
– Robotic mower was operated on a
different mowing area. Wire signal of
second docking station is already
stored.
Remedy:
– Perform new installation (Ö 11.13)
Message:
2400 – iMOW® successfully reset to
factory default
Possible cause:
– Robotic mower has been reset to
factory default
Remedy:
– Confirm message with OK
Message:
4000 – Voltage fault
Battery overvoltage or undervoltage
Possible cause:
– Battery overvoltage or undervoltage
Remedy:
– No action required, firmware will be
automatically updated if necessary
– Contact your STIHL specialist dealer if
the problem persists
Message:
4001 – Temperature fault
Outside temperature range
Possible cause:
– Temperature in battery or inside
machine too low or too high
Remedy:
– Allow robotic mower to warm up or cool
it down – observe permissible
temperature range of battery (Ö 6.4)
Message:
4002 – Rollover
see message 1000
Message:
4003 – Hood lifted
Check hood
Then press OK
Possible cause:
– Hood has been lifted
Remedy:
– Check the hood and confirm the
message with OK