Stratasys Objet260 - Page 185

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-52
5. Inthefollowingscreen,selectContinuewithHeadoptimizationifyouhave
recentlycleanedtheprintheads.Otherwise,cancelthewizardandrunthe
HeadCleaningwizard.
Figure6-68Cleanprintheadsscreen
6. Inthefollowingscreen,selectReplacefaultyheads,andclickNext.
Figure6-69Procedureselectionscreen
PreparingthePrintBlock
7. Selecttheprinthead(s)needingreplacement,andclickNext.
Figure6-70Headselectionscreen