Stratasys Objet260 - Page 186

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-53
Theprinterheatsandemptiestheprintblock,andpreparestheprinter.
(Thisshouldtakeupto15minutes.)
Figure6-71Printerpreparationprogressscreen
8. Thefollowingscreenappearswhentheprinterisreadyforyoutoreplace
printheads.
Figure6-72Printerreadyforheadreplacement
9. Putontheprotectiveglovesandopentheprintercover.
Note:Theprinterdisconnectspowertotheheadsforyoursafety.