Stratasys Objet260 - Page 197

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-64
Figure6-93LabelonthebottomoftheUVsensorbox
Thebuildtraylowers.
2. ConnecttheUVsensorcabletotheconnectorintheprinter.
Figure6-94UVsensorconnectorintheprinter
3. PositiontheUVsensorasshowninthewizardscreen.
Toensurethatthesensorcabledoesnotinterferewiththebuildtraywhen
itisraised,routeitinbackofthesensor.
Figure6-95Sensorpositioning
4. ConfirmtheitemslistedinthewizardscreenandclickNext.