Stratasys Objet260 - Page 196

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-63
4. Makesurethatthebuildtrayisinplaceandclear(empty),confirmthisin
thewizardscreenandclickNext.
Figure6-91Printerpreparation
➢ WhenusingaStratasysUVsensorboxthatyouconnecttotheprinter
(TOL-03005-S),continuewith"UVSensorConnectedtoPrinter"below.
➢ Whenusingastand-aloneUVradiationmeter,continuewith"External
UVMeter"onpage6-65.
UVSensorConnectedtoPrinter
ThefollowingstepsapplywhenusingtheStratasysUVsensorboxthatyou
connecttotheprinter.TheydonotapplywhenusingaUVexternalradiation
measuringdevice.
1. TosynchronizethewizardandtheUVsensor,entertheCFnumberfrom
thelabelonthebackoftheUVsensorboxandclickNext.
Figure6-92UVsensorsynchronization