Status LEDs and System Buttons
Troubleshooting the Hardware
3-11
Blinking green/yellow
(source disk)
Blinking green
(target disk)
Do not remove. The source disk is resynchronizing its partner
disk. The LED appears to flash rapidly, alternating between
green and yellow. (Actually,
the green LED is blinking on
access and may appear always on. The yellow LED is
blinking at approximately 0.5 Hz.)
Although it is safe to remove the target disk, doing so
necessitates a full resynchronization when the disk is
reinserted. The green LED flashes rapidly during
resynchronization.
Steady yellow Safe to remove. Disk drive is broken.
Action: Verify that the drive is properly installed. Verify the
connection by removing and replacing the drive. If necessary,
replace the drive with a new one.
See your system administration documentation for information
about component failures and ways to correct them.
If you are unable to fix the condition, contact the CAC or your
authorized Stratus service representative.
Table 3-4. Hard Disk Drive LEDs
(Continued)
Status Description
To Next Page
Loading...
