Installing and Replacing System Components
5-1
Chapter 5
Installing and Replacing System
Components
5-
The following topics describe CRU replacement procedures:
• “Before Replacing CRUs” on page 5-2
• “Removing the Bezel” on page 5-4
• “Removing and Replacing a Front Panel” on page 5-6
• “Removing and Replacing a CPU-I/O Enclosure” on page 5-8
• “Removing and Replacing a CPU-I/O Enclosure Cover” on page 5-15
• “Removing the Plenum” on page 5-18
• “Replacing the System Backplane Assembly” on page 5-19
• “Replacing and Adding DIMMs” on page 5-24
• “Removing and Replacing the CPU-I/O Enclosure Fan Assembly” on page 5-30
• “Removing and Replacing the Power Supply Fan” on page 5-32
• “Removing and Installing a Low-Profile PCI Adapter” on page 5-34
• “Replacing a PCI Riser Assembly and Its Adapters” on page 5-38
• “Removing and Inserting an Internal Hard Disk Drive” on page 5-44
• “Removing and Replacing a DVD Drive” on page 5-46
• “Replacing or Installing a Modem Assembly” on page 5-48
• “Removing and Replacing a PDU” on page 5-51
See the
ftScalable Storage: Operation and Maintenance Guide
(R600) or the
ftScalable Storage G2: Operation and Maintenance Guide
(R650) for information
about removing and replacing CRUs in an ftScalable Storage system.
To Next Page
Loading...
