SummaCut User’s Manual
General Information 1-2
• 8-key control panel.
• Convenient operator control via a 16-character liquid crystal display.
• Metric or English units.
• Menu mode for selection of the cutter’s power-up operating configuration, controlled
by microprocessor.
• Wide variety of axial cutting speeds (in metric or English units).
• Up to four separate user configurations stored in the non-volatile memory.
• Automatic media pull from roll.
• Automatic end of media sensing.
• Manual knife for cutting off the finished sign.
• Knife depth and offset test.
• Overcut for easy weeding.
• User-selectable DM/PL
™
, HP-GL
™
and HP-GL/2
™
software protocols.
• Multiple recut feature.
• OPOS 2.0 (factory installed SE option)
• Optional stand with basket (Standard for D120(SE), D140SE and D160SE).
To Next Page
Loading...
