6-8 Sun StorEdge 3000 Family Installation, Operation, and Service Manual • May 2004
2. If you want to view or change the “Fibre Connection Option,” choose either “Loop
only” or “Point to point only.”
Caution – Do not use the bottom command, “Loop preferred, otherwise point to
point.” This command is reserved for special use and should be used only if directed
by technical support.
A confirmation dialog is displayed.
3. Choose Yes to confirm.
A confirmation message is displayed:
4. Choose Yes to reset the controller.
6.1.5 Editing and Creating Additional Host IDs
(Optional)
All RAID arrays are preconfigured when they arrive from the factory. Default host
channel IDs are displayed in
TABLE 6-1.
NOTICE: Change made to this setting will NOT take effect until the
controller is RESET. Prior to resetting the controller, operation
may not proceed normally. Do you want to reset the controller now?
To Next Page
Loading...
Need help?
General
