G-1
APPENDIX
G
Configuring a Windows 200x Server
or Windows 200x Advanced Server
This appendix provides platform-specific host installation and configuration
information to use when you connect a Sun StorEdge 3510 or 3511 FC Array to a host
running the Windows 2000 Server, Windows 2000 Advanced Server, Windows 2003
Server, or Windows 2003 Advanced Server operating system. For convenience, these
platforms will be referred to collectively in this document as “Windows 200x server.”
The Sun StorEdge 3510 and 3511 FC Arrays supports Microsoft Windows 2000 Server
and Microsoft Windows 2000 Advanced Server, Service Pack 3 or greater, in dual-
path configurations using Sun StorEdge Traffic Manager 3.0 failover drivers for
Microsoft Windows 2000.
If you are going to use dual-path instead of single-path configuration, refer to the
Sun StorEdge Traffic Manager 3.0 Installation and User’s Guide for Microsoft Windows
2000 and Windows NT for detailed instructions about setting up the device driver on
the server and for additional information about configuring your Windows 2000
Server or Advanced Server.
Customers interested in Sun StorEdge Traffic Manager 3.0 for multiplatform support
should contact Sun Sales or visit:
http://www.sun.com/sales
For more information about multiplatform support, see:
http://www.sun.com/storage/san/multiplatform_support.html
The information in this appendix supplements the configuration steps presented in
Chapter 6, and covers the following steps:
■ “Setting Up the Serial Port Connection” on page G-2
■ “Accessing the Firmware Application From a Windows 200x Server or Windows
200x Advanced Server” on page G-5
To Next Page
Loading...
Need help?
General
