B-1
APPENDIX
B
Using a Standalone JBOD Array
(Sun StorEdge 3510 FC Array Only)
A single Sun StorEdge 3510 FC JBOD array can be connected directly to certain
Solaris operating system hosts. This appendix describes the use of Sun StorEdge
3510 FC JBOD arrays.
Note – Sun StorEdge 3511 FC does not support the use of JBOD arrays.
The topics covered in this appendix are:
■ “Supported Configurations (JBOD Arrays)” on page B-2
■ “Supported Operating Systems (JBOD Arrays)” on page B-2
■ “Supported Host Platforms and Connection Methods (JBOD Arrays)” on page B-2
■ “Known Limitations Affecting Sun StorEdge 3510 FC JBOD Arrays” on page B-3
■ “Using Sun StorEdge 3000 Family Software Monitoring and Management Tools
with JBOD Arrays” on page B-4
■ “Setting the Loop ID on a Sun StorEdge 3510 FC JBOD Array” on page B-6
■ “Connecting Sun StorEdge 3510 FC JBOD Arrays” on page B-7
■ “Enabling Sun StorEdge 3510 FC JBOD Array Support” on page B-11
■ “Downloading Firmware to Disk Drives in a JBOD” on page B-13
■ “Resizing LUNs Greater than 1 TByte” on page B-13
■ “Troubleshooting Sun StorEdge 3510 FC JBOD Arrays” on page B-14
■ “Converting a JBOD to a RAID array” on page B-19
To Next Page
Loading...
Need help?
General
