Appendix B Using a Standalone JBOD Array (Sun StorEdge 3510 FC Array Only) B-5
B.5.1.1 Enabling JBOD Support
To monitor peripheral device conditions and events on a Sun StorEdge 3510 FC
JBOD array from the Sun StorEdge Configuration Service Console, you first need to
enable JBOD support. See “Enabling Sun StorEdge 3510 FC JBOD Array Support” on
page B-11 for the procedure for enabling JBOD support.
B.5.2 Sun StorEdge Diagnostic Reporter
Sun StorEdge Diagnostic Reporter supports standalone JBOD arrays. However,
triggered event notification is limited to environmental failures and hard drive
failures.
B.5.3 Sun StorEdge CLI
The Sun StorEdge CLI supports JBOD arrays. However, because JBOD arrays do not
have a RAID controller to manage the disks, this command-line interface support is
limited to the following commands:
■ about
■ download pld-firmware
■ download ses-firmware
■ exit
■ help
■ quit
■ select
■ show frus
■ show inquiry-data
■ show pld-revision
■ show ses-devices
■ version
Refer to the Sun StorEdge 3000 Family CLI User’s Guide for information about using
these commands.
To Next Page
Loading...
Need help?
General
