Contents vii
6.1.8.2 Sun StorEdge 3511 FC Array Default
Configurations 6–15
6.1.9 Completing Basic Configuration 6–16
6.1.10 Preparing for Logical Drives Larger Than 253 Gbyte 6–17
6.1.11 Deleting Logical Drives 6–19
6.1.12 Creating Logical Drives 6–21
6.1.13 Changing a Logical Drive Controller Assignment (Optional) 6–28
6.1.14 Creating or Changing a Logical Drive Name (Optional) 6–30
6.1.15 Partitioning a Logical Drive (Optional) 6–31
6.2 Mapping Logical Drive Partitions to Host LUNs 6–35
6.2.1 Planning for 1024 LUNs (Optional, Loop Mode Only) 6–37
6.2.2 Using the Map Host LUN Option 6–37
6.2.3 Setting Up Host Filter Entries 6–42
6.2.3.1 Creating Host Filter Entries 6–44
6.2.4 Creating Device Files for the Solaris Operating Environment 6–51
6.2.5 Saving Configuration (NVRAM) to a Disk 6–52
6.3 Using Software to Monitor and Manage the Sun StorEdge
Fibre Channel Array 6–53
6.3.1 Other Supported Software 6–54
6.3.2 Enabling VERITAS DMP 6–54
6.3.3 The VERITAS Volume Manager ASL 6–55
7. Checking LEDs 7–1
7.1 LEDs When The Array Is First Powered On 7–1
7.2 Front Panel LEDs 7–2
7.2.1 Correcting SES or PLD Firmware Version Conflicts 7–4
7.3 Back Panel LEDs 7–4
7.3.1 I/O Controller Module LEDs 7–5
7.3.2 Power Supply and Fan Module LEDs 7–8
To Next Page
Loading...
Need help?
General
