SUNSTONE CDDP-A - Writing to a Single Coil

Questions? Call or Text +1-801-658-0015 • 49
e Micro Welder Experts
WRITING TO A SINGLE COIL
To write to a single coil, follow these instructions:
• On the main screen click the Write button (A) near the bottom of the window as shown in Figure 49.1.
• A new window will appear. See Figure 49.2. In this new window, make sure Mode is set to TCP
• Set #Values to Write to 1.
• Change the function code to 5, with Register Size set to 1 bit coils.
• Change the Values to Write to 1.0000.
• Change the Data Type to 1 bit Boolean.
• Click the Send button to relay the instructions to the CDDP-A.
In this example, the Pulse 1 Power Comparator Enable state was changed to ON, which should be noted on the
CDDP-A’s screen.
If you change the values to Write to 0.0000 and click on the Send button, you’ll change the state to OFF.
Figure 49.2.
Figure 49.1.
A