SUNWARD SWE18UF - Operation Instruction of Auxiliary Circuits; Safety Note; Note for Attachment Assembly

OPERATION & MAINTENANCE MANUAL SWE18UF
121
9 OPERATION INSTRUCTION OF AUXILIARY CIRCUITS
9.1 SAFETY NOTE
Warning：
 Please consult Sunward dealer before installing optional parts；
 Don’t use other option attachment which is not agreed by Sunward or Sunward dealer, or it will shorten
the service life of the machine and cause other safety problems.
 Sunward will not be responsible for any hurt, accidents or machine damage which is caused by using
unauthorized option attachment;
 According to the statement, vibration noise will difficult to make colleague send operation instructions.
Before operating, please appoint one commander and confirm all signals.
 Select flat hard ground to operate and make sure there’s good light and ventilation.
 Clear up the working area, clear away obstacles and dangerous objects, and the leaked lubricating oil and
grease on the ground.
 Appoint one person to conduct operation and obey his instruction when the machine is lifting.
 Park the machine on a stable position to avoid tipping when assembling or disassembling the working
device.
 Unauthorized person is not allowed in the working area, as for there’s the risk of falling of loaded objects.
 A crane should be used when lifting or moving a heavy object exceeding 25kg.
 Replace optional work device or other special work device, please do the running-in first and then check
oil level, if necessary, please fill oil. Consult local Sunward dealer about details for assembly and
disassembly.
9.2 NOTE FOR ATTACHMENT ASSEMBLY
Warning：
 Extended or heavy work attachment will decrease the stability of machine, so if travelling or
slewing on the slope, the machine may tip. The following operation is dangerous, it’s forbidden
to do so.
1. When travelling downhill, lower the center of gravity of work device to avoid tipping forward.
2. Forbid travelling along the slope to avoid roll-over.
3. It’s forbidden to swing on the slope.
4. After a heavy work device is installed, the swing exceeding stroke of the machine will increase (the
distance is that the position when stopping the swing operation to the position the machine stops swing).
Wrong estimation of the swing exceeding stroke may make the machine colliding with surrounding objects, so
enough distance should be kept during operation. Besides, nature falling will also increase (the work device
will decrease gradually as for its gravity)