OPERATION & MAINTENANCE MANUAL SWE18UF
24
Ensure that travel alarm is functioning properly. Be
alert that no bystander accesses to jobsite. Sound horn
or use other alarm to warn people.
When machine travels in reverse, provide a flagman to
assist in case operator’s sight is limited. Keep the
flagman with operator’s sight
When signal is needed during working, signal man be
suppose to use hand signal. Only when the signals are
understood by both signal man and operator, the
machine can be operated to tram or swing.
Understand all flags, signs and signals being used
during operation. Select the person who is responsible
to signal.
Keep windows, mirrors and light fittings clean.
In case of improper visibility arising from dust, rain, or
fog etc. use appropriate lighting device.
Please read and understand all safety rules described in
this manual.
1.3.9 Avoiding Accidents Caused By Control Failures
Warning: When the machine is out of control, any
attempt to mounting or to stop a moving machine can
result in severe injury or even death.
To avert runaway, it’s necessary to park machine
properly.
Always park the machine on level ground, do not park
the machine on a slope.
Lower the bucket to ground.
Allow the engine to run at low speed for 3 minutes to
cool down the machine.
Stop the engine, remove the key.
Turn off the pilot control switch.
When the machine is to park on a slope, chock the
machine on both side of the track, lower bucket to dig
the teeth into the ground.
Position the machine to avoid unexpected movement.
Keep proper distance from the other machine.
To Next Page
Loading...
