OPERATION & MAINTENANCE MANUAL SWE18UF
22
Keep jobsite off-limits to all no operating person.
Make sure the condition of worksite is stable and
capable of supporting the machine.
To make it easy to escape if there is any collapse, set
the tracks at right angle to the pit with sprocket at the
rear when carrying out operation near pit.
When digging the work face under an overhang, the
overhang may collapse and fall on top of the machine.
Do not place bucket above the head of person or
operator cab. Falling objects from bucket or collision
with bucket can cause serious injury or death or damage
to machine.
When using breakout hammer or other heavy working
equipment, there is a hazard of losing its balance and
tipping over.
Do not lower, swing or stop working device all of
sudden.
Do not extend or retract boom cylinder suddenly,
There is a risk of machine tipping over due to impact
force.
1.3.5 Operation on Slopes
When operating swing or working device during
operation on slopes, there is a risk that the machine may
lose its balance or tip over. This may cause serious
injury or damage to machine. So it’s necessary to
provide a flatness area for the machine and operate
carefully.
Do not swing machine from uphill side to downhill side,
when bucket is fully loaded. This dangerous act can
cause machine to tip over.
If the machine has to be used on a slope, pile the soil to
make a platform which can keep machine as horizontal
as possible.
1.3.6 Operation on Snowy Ground
Snow coated or frozen ground is slippery. So pay
extreme attention when tramping or operating machine.
Do not operate control lever suddenly. Pay much
attention when operating on a slope even a slight slope.
Frozen ground will become soft along with the increase
To Next Page
Loading...
