OPERATION & MAINTENANCE MANUAL SWE18UF
25
1.3.10 Moving Machine Safely
Before moving the machine, check travel control lever
(pedal) to ensure the relationship between operation
direction and machine movement direction.
Before moving the machine, make sure the working
area is free of other persons and obstacles, and sound
the horn to alert.
Bypass any obstacles during traveling.
When traveling, swing, operating working device in
confined area, position a signal person and define the
meaning of the signals beforehand.
1.3.11 Safety Rules During Traveling
During operation of machine, do not operate exceeding
max load capacity or performance to avoid stall and
damage to work attachment.
When traveling on flat ground, retract work attachment
(as shown in right figure).
When traveling on rough ground, travel at low speed.
Do not steer sharply, there is a risk of machine turning
over. The work device may hit the ground and cause
machine to lose its balance or damage the machine or
structures.
When traveling on rough ground or on slope, disable
the auto-reduction switch( if present), if auto-reduction
switch is on, engine revs may increase. This may cause
machine to speed up abruptly.
Avoid traveling on obstacles if possible. if the machine
has to travel on obstacles, lower the working device
close to the ground at low speed. Do not travel over
obstacles which involve risk of tilting machine to one
side.
When traveling or operating, keep a safe distance from
people, structure or other machine to avoid making
contact with them.
When passing over bridges or structures, check first
structure is strong enough to support the weight of the
machine. When traveling on road, contact relevant
authorities and follow there instructions.
When operating in tunnel, under bridges, under electric
wires or other height-limited area, operate slowly and
To Next Page
Loading...
