OPERATION & MAINTENANCE MANUAL SWE18UF
15
1.2.12 Ensuring Perfect Visibility
Stop the machine if the fog, rain, snow or dust has negative effects on your visibility.
To work at dark, make sure the lighting device can function normally.
1.2.13 Leaving Operation Seat Safely
Warning: Unexpectedly touching unlocked pilot safety control lever can result in sudden movement
of the machine and cause injury or damages to the machine.
When operator tends to leave or stand up off the seat( to open or close front or upper windows, remove or
install front lower windows, adjust seat), please lower the work equipment to the ground, set pilot safety
control lever to LOCK position securely, then stop the engine.
1.2.14 No Passengers Allowed
When machine is in the process of operation or traveling, do not allow anyone to ride on the machine
other than the operator. Because there is a hazard that passengers may fall off or get hit by foreign body.
Passenger may block operator’s sight to result in unsafe operation.
Do not allow anyone to sit on bucket or other front attachments. Serious injury can occur to person.
1.2.15 Worksite Safety
Thoroughly inspect worksite for any abnormal danger situations prior to operation.
Operate with extra care for any operation in vicinity of flammable materials such as thatched roof, dry
leaves or dry grass.
Survey terrain and ground condition around worksite. Determine a safest operation method in a safe
manner.
Do not operate in vicinity of the area in which there is a risk of landslide or falling rock.
At the work around place of water or gas lines, or cables underground. Contact relevant utility to identify
their locations. Pay attention not to rapture or damage any of these lines.
Take necessary measures to prevent any unauthorized person from entry into work area.
In the event of operation over soft ground or in shallow water, it’s necessary to check type and condition
of rock bed, and take water depth, flow speed into account prior to operation.
In the event of operation in vicinity of over bridge or overhead stuff, be cautious not to collide with front
working device of machine.
1.2.16 Operation on Loosened Area
Do not operate around cliff, shoulder of road or ditch. In this area, the ground
is loosened. There is a possibility of getting into danger of ground sinking with
vibration and weight of the machine. Bear in mind that the soil is loosened in
this area after heavy rain, explosion operation or earthquake.
When working on a dike or around ditch, there is a possibility of getting into
danger of ground sinking resulting from vibration or weight of the machine.
It’s necessary to take measures to secure safety against tip-over and falling off.
To Next Page
Loading...
