SUNWARD SWE18UF - During Storage; After Storage

OPERATION & MAINTENANCE MANUAL SWE18UF
40
 Disconnect battery negative terminal and secure battery
cover. You can also remove the battery from the
machine, store it separately.
 If the expected ambient temperature may below 0°C
(32°F), mix coolant with anti-freezing liquid.
 Select proper storage position： The machine must be
kept at well-ventilated indoor place, if the machine has
to be stored outdoors, select level, firm ground and
cover the machine with a sheet.
2.2.2 During Storage
Note
 When it's necessary to perform the rust-preventive
operation while the machine is at indoor, open the
doors and windows to ventilate and prevent gas
poisoning.
 During storage, operate the machine to travel, swing and dig
for 2 to 3 cycles at least once a month so as to lubricate
machine, and charge the machine battery.
 Before operating, check cooling water level and lubrication
status.
 Air condition must run once a month.
2.2.3 After Storage
Note
 Start engine only in well-ventilated condition.
 Remove lubricating grease on piston rod surface.
 Apply grease to all lubricating parts.
 Check engine oil level, keep it in specified level, if not,
and refill engine oil. If some water is found to mix in
the oil, replace it.
 Check fuel level and bleed the air.
 Check its level to ensure that it is with the standard
range.
 Start and run the engine at half speed for several
minutes before operation with full load.
 Cycle all hydraulic function for several times.