OPERATION & MAINTENANCE MANUAL SWE18UF
83
The reading will be imprecise if
check oil level immediately after
stopping machine. Make sure to cool
down the engine oil at least 15
minutes before inspection.
500 hours.
Please maintain as per the requirement in diesel engine manual book.
【NOTE】：
Excavators which delivered from the factory, have been filled with engine
oil labeled by ★.
Check engine oil level
1) Park the excavator on a level ground.
2) Take out dipstick, wipe the oil with clean cloth, and insert dipstick into engine again.
3) Take out dipstick again, the oil level must lie between MAX and MIN marks.
4) Fill engine oil through filler filter if necessary. Make sure to use recommended oil.
Replace engine oil
The engine oil and oil filter must be replaced after the first 50 hours’ operation.
After first replacement, please carry out replacement as per <YANMAR operation and maintenance manual >.
Replace engine oil filter…every 500 hours
Steps for replacing engine oil and filter
1) Warm up engine oil before startup, but don’t overheat.
2) Park the excavator on a level ground.
3) Lower the bucket to ground.
4) Run engine idle for 5 minutes.
5) Shut off engine, and take out key switch.
6) Pull the pilot control lever to lock position.
7) Take off the outlet plug, pour the oil into a 10L container through a clean cloth.
The performance of engine oil is very
different, commonly the engine oil adopts
API or CCMC standard.
In order to get correct value, check
oil level before starting engine every
day and make sure to park the excavator
on level ground.
The engine oil may be very hot,
please be cautious of scalding.
To Next Page
Loading...
