Boot URI
Enter a Boot Uniform Research Identifier (URI) with 128 characters or shorter. This Boot URI
determines how IPv4 Boot Option and IPv6 Boot Option will be created. This feature is only
supported on Dual or EFI Boot Mode.
Instance of Priority 2: (Available when "HTTP Boot Policy" is set to Apply to each LAN
or Boot Priority #1 instantly)
This feature sets the rank target port. The default setting is 0.
Super IO Configuration Menu
►Super IO Configuration
The following information is displayed.
l
Super IO Chip
Note: This submenu is available when your system supports this feature.
Serial Port 1 Configuration Menu
►Serial Port 1 Configuration
Serial Port 1
Select Enabled to enable serial port 1. The options are Disabled and Enabled.
Device Settings (Available when "Serial Port 1" above is set to Enabled)
This feature displays the base I/O port address and the Interrupt Request address of serial port
1.
Change Settings (Available when "Serial Port 1" above is set to Enabled)
Use this feature to specify the base I/O port address and the Interrupt Request address of serial
port 1. Select Auto for the BIOS to automatically assign the base I/O and IRQ address to serial
port 1. The options are Auto, (IO=3F8h; IRQ=4;), (IO=3F8h; IRQ=3,4,5,6,7,9,10,11,12;),
(IO=2F8h; IRQ=3,4,5,6,7,9,10,11,12;), (IO=3E8h; IRQ=3,4,5,6,7,9,10,11,12;), and (IO=2E8h;
IRQ=3,4,5,6,7,9,10,11,12;).
104
X14SAE/X14SAE-F: UEFI BIOS
To Next Page
Loading...
