EasyManua.ls Logo

Supermicro X14SAE - Network Stack Configuration Menu; MAC:(MAC Address)-Ipv4 Network Configuration Menu

Supermicro X14SAE
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Network Stack Configuration Menu
►Network Stack Configuration
Network Stack
Select Enabled to enable Preboot Execution Environment (PXE) or Unified Extensible
Firmware Interface (UEFI) for network stack support. The options are Disabled and Enabled.
IPv4 PXE Support (Available when "Network Stack" is set to Enabled)
Select Enabled to enable IPv4 PXE boot support. If this feature is disabled, it will not create the
IPv4 PXE boot option. The options are Disabled and Enabled.
IPv4 HTTP Support (Available when "Network Stack" is set to Enabled)
Select Enabled to enable IPv4 HTTP boot support. If this feature is disabled, it will not create
the IPv4 HTTP boot option. The options are Disabled and Enabled.
IPv6 PXE Support (Available when "Network Stack" is set to Enabled)
Select Enabled to enable IPv6 PXE boot support. If this feature is disabled, it will not create the
IPv6 PXE boot option. The options are Disabled and Enabled.
IPv6 HTTP Support (Available when "Network Stack" is set to Enabled)
Select Enabled to enable IPv6 HTTP boot support. If this feature is disabled, it will not create
the IPv6 HTTP boot optiont. The options are Disabled and Enabled.
PXE Boot Wait Time (Available when "Network Stack" is set to Enabled)
Use this feature to set the wait time (in seconds) upon which the system BIOS will wait for you
to press the <ESC> key to abort PXE boot instead of proceeding with PXE boot by connecting
to a network server immediately. Press the <+> or <-> key on your keyboard to change the
value. The default setting is 0.
Media Detect Count (Available when "Network Stack" is set to Enabled)
Use this feature to set the wait time (in seconds) for the BIOS ROM to detect the presence of a
LAN media either via the Internet connection or via a LAN port. Press the <+> or <-> key on
your keyboard to change the value. The default setting is 1.
MAC:(MAC address)-IPv4 Network Configuration Menu
►MAC:(MAC address)-IPv4 Network Configuration
Configured
Enable this feature to configure network addresses for DHCP, local IP address, local netmask,
local gateway, and local DNS server. The options are Disabled and Enabled.
105
X14SAE/X14SAE-F: UEFI BIOS

Table of Contents

Related product manuals