Appendix A:
BIOS Codes
For information about BIOS codes for the X14SAE/X14SAE- F motherboard, refer to the
following content.
BIOS Error POST (Beep) Codes
During the Power-On Self-Test (POST) routines, which are performed each time the system is
powered on, errors may occur.
Non-fatal errors are those which, in most cases, allow the system to continue the boot up
process. The error messages normally appear on the screen.
Fatal errors are those which will not allow the system to continue the boot up process. If a fatal
error occurs, you should consult with your system manufacturer for possible repairs.
These fatal errors are usually communicated through a series of audible beeps that can be
heard on an external buzzer connected to JD1. The table shown below lists some common
errors and their corresponding beep codes encountered by users.
BIOS Beep (POST) Codes
Beep Code Error Message Description
1 beep Refresh Circuits have been reset (Ready to power up)
5 short, 1 long Memory error No memory detected in system
5 short, 2 long
Display memory
read/write error
Video adapter missing or with faulty memory
1 long continuous System OH System overheat condition
Additional BIOS POST Codes
The AMI BIOS supplies additional checkpoint codes, which are documented online at
https://www.supermicro.com/support/manuals ("AMI BIOS POST Codes User's Guide").
For information on AMI updates, refer to https://www.ami.com/products.
141
X14SAE/X14SAE-F: BIOS Codes
To Next Page
Loading...
