2.6 M.2 Device Installation
This motherboard has one PCIe 5.0 M.2 M-key slot (M.2-C1) that supports the M.2 2280
modules and one PCIe 4.0 M.2 M-key slot (M.2-P1) that supports the 2280/22110 modules.
Two standoffs are pre-installed in the position of 2280 mounting hole (M.2-C1) and 22110
mounting hole (M.2-P1). Follow the steps below to install the M.2 device.
Notes:
l
The installation described in this section is for reference only. The actual installation
steps may vary depending on the supported M.2 form factors and the standoff pre-
installed location.
l
Images displayed are for illustration purposes only. Your components might look
different from those shown in this manual.
Installing a Standard M.2 Device
1. Locate the screw on the pre-installed standoff. Remove the screw and set it aside.
Figure 2-20. Remove the Screw on the Pre-installed Standoff
50
X14SAE/X14SAE-F: Component Installation
To Next Page
Loading...
