Installing an M.2 Device with Heatsink (Optional)
It is strongly recommended that you install an M.2 heatsink provided by the M.2 device
supplier. If you are using a Supermicro M.2 heatsink, follow the steps below:
Note: Images displayed are for illustration only. Your M.2 heatsink may not look exactly the
same as the graphics shown in the manual.
1. Remove the thermal pad protective films from the cover and the tray of the M.2 heatsink.
Figure 2-24. Remove the Protective Films from the Heatsink
2. Place the M.2 device into the tray, then put the heatsink cover in place. Be careful to
align the tray holes with the cover holes.
Figure 2-25. Create the M.2 Heatsink Assembly
52
X14SAE/X14SAE-F: Component Installation
To Next Page
Loading...
