TPM Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1–2 Enabled (Default)
Pins 2–3 Disabled
VGA Enable/Disable (X14SAE-F)
Jumper JPG1 allows you to enable the onboard VGA connector on the X14SAE- F
motherboard. The default setting is pins 1–2 to enable the connection.
For a detailed diagram of the X14SAE/X14SAE-F motherboard, see the layout under "Quick
Reference" on page 13.
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1–2 Enabled (Default)
Pins 2–3 Disabled
Watchdog Timer
Watchdog (JWD1) is a system monitor that can reboot the system when a software application
hangs. Close pins 1–2 to reset the system if an application hangs. Close pins 2–3 to generate a
non-maskable interrupt (NMI) signal for the application that hangs. The Watchdog must also be
enabled in the BIOS.
For a detailed diagram of the X14SAE/X14SAE-F motherboard, see the layout under "Quick
Reference" on page 13.
Watchdog Timer
Jumper Settings
Jumper Setting Definition
Pins 1–2 Reset (Default)
Pins 2–3 NMI
Open Disabled
74
X14SAE/X14SAE-F: Component Installation
To Next Page
Loading...
