Wait For "F1" If Error
Select Enabled to force the system to wait until the <F1> key is pressed if an error occurs. The
options are Disabled and Enabled.
Re-try Boot
If this feature is set to Enabled, the system BIOS will automatically reboot the system from an
Extensible Firmware Interface (EFI) boot device after an initial boot failure. The options are
Disabled and Enabled.
Power Configuration
Watch Dog Function
Select Enabled to allow the Watch Dog timer to reboot the system when it is inactive for more
than five minutes. The options are Disabled and Enabled.
Watch Dog Action (Available when "Watch Dog Function" is set to Enabled)
Use this feature to configure the Watch Dog Time_out setting. The options are Reset and NMI.
DeepSx Power Policies
Use this feature to configure the Advanced Configuration and Power Interface (ACPI) settings
for the system. Enable S4 to use Hibernation mode (Suspend to Disk) so that all data stored in
the main memory can be saved in a non-volatile memory area such as in a hard drive and then
power down the system. Enable S5 to power off the whole system except the power supply unit
(PSU) and keep the power button alive so that you can wake up the system by using a USB
keyboard or mouse. The options are Disabled, Enabled In S4-S5, and Enabled in S5.
Delay Time Before PCI Enumeration
Use this feature to set the amount of time the system waits before enumerating PCI devices
during the boot process. The valid range is 0–30 with a step of 1 second. The default setting is
0 for off, meaning the system will skip the delay time and immediately begin enumerating PCI
devices.
CPU Configuration Menu
►CPU Configuration
Important: Setting the wrong values for the features included in the following sections may
cause the system to malfunction.
The following processor information is displayed.
94
X14SAE/X14SAE-F: UEFI BIOS
To Next Page
Loading...
