EasyManua.ls Logo

Supermicro X14SAE - Front Panel Audio Header; Internal Speaker;Buzzer

Supermicro X14SAE
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
For a detailed diagram of the X14SAE/X14SAE-F motherboard, see the layout under "Quick
Reference" on page 13.
4-pin Fan Header
Pin Definitions: Four Total
Pin# Definition
1 GND (Black)
2 +12 V (Red)
3 Tachometer
4 PWM Control
Front Panel Audio Header
A 10-pin audio header located at AUDIO_FP/AUDIO FP is supported on the X14SAE/X14SAE-
F motherboard. This header allows you to connect the motherboard to the audio port on the
front panel. If needed, connect an audio cable (not supplied) to the audio header to use this
feature.
Note: The audio header's default setting is for a headphone/microphone combo jack. If you
want to connect it to HD Audio or AC'97 audio port, configure the Frontside Audio Mode
feature in the BIOS Setup utility.
For a detailed diagram of the X14SAE/X14SAE-F motherboard, see the layout under "Quick
Reference" on page 13.
Front Panel Audio Header
Pin Definitions: 10 Total
Pin# Definition Pin# Definition
1 Microphone_Left 6 GND
2 Audio_GND 7 Jack_Detect
3 Microphone_Right 8 Key
4 Audio_Detect 9 Line_2_Left
5 Line_2_Right 10 GND
Internal Speaker/Buzzer
The Internal Speaker/Buzzer (SP1) is used to provide audible indications for various beep
codes.
66
X14SAE/X14SAE-F: Component Installation

Table of Contents

Related product manuals