SlimSAS 8i Connector
A PCIe 4.0 x8 SlimSAS 8i connector is located at PCH_ PE1 0- 7 (x4/ x4) on the
X14SAE/X14SAE-F motherboard. The connector is supported by the PCH and it supports two
PCIe 4.0 x4 U.2 connections.
Standby Power
The Standby Power header is located at JSTBY1 on the motherboard. You must have a card
with a Standby Power connector and a cable to use this feature.
For a detailed diagram of the X14SAE/X14SAE-F motherboard, see the layout under "Quick
Reference" on page 13.
Standby Power
Pin Definitions: Three Total
Pin# Definition
1 +5 V Standby
2 GND
3 GND
TPM/Port 80 Header
The JTPM1 header on the X14SAE/X14SAE-F motherboard is used to connect a Trusted
Platform Module (TPM)/Port 80, which is available from Supermicro (optional). A TPM/Port 80
connector is a security device that supports encryption and authentication in hard drives. It
allows the motherboard to deny access if the TPM associated with the hard drive is not installed
in the system. Go to the following link for more information on the TPM:
https://www.supermicro.com/manuals/other/AOM-TPM-9670V_9670H__X12_H12.pdf.
For a detailed diagram of the X14SAE/X14SAE-F motherboard, see the layout under "Quick
Reference" on page 13.
Trusted Platform Module Header
Pin Definitions: 10 Total
Pin# Definition Pin# Definition
1 +3.3 V 2 SPI_CS#
3 RESET# 4 SPI_MISO
5 SPI_CLK 6 Ground
7 SPI_MOSI 8 No Connection
9 +3.3 V Stdby 10 SPI_IRQ#
69
X14SAE/X14SAE-F: Component Installation
To Next Page
Loading...
