Supermicro X14SAE - Advanced Configuration; MAC:(MAC Address)-Ipv4 Network Configuration Menu

Interface ID
Use this feature to change/enter the 64-bit alternative interface ID for the device. The string
format is colon separated. The default setting is the MAC address above.
DAD Transmit Count
Use this feature to set the number of consecutive neighbor solicitation messages have been
sent while performing duplicate address detection on a tentative address. The default setting
is 1.
Policy
Use this feature to select how the policy is to be configured. The options are automatic and
manual.
►Advanced Configuration
Note: This submenu is available when "Policy" is set to manual.
New IPv6 address: Use this feature to enter the IPv6 address for the local machine.
New Gateway addresses: Use this feature to set the gateway address for the local
machine.
New DNS addresses: Use this feature to set the DNS server address for the local
machine.
Commit Changes and Exit: Press <Enter> to save changes and exit.
Discard Changes and Exit: Press <Enter> to discard changes and exit.
Save Changes and Exit
Press <Enter> to save changes and exit.
MAC:(MAC address)-IPv4 Network Configuration Menu
►MAC:(MAC address)-IPv4 Network Configuration
Configured
Enable this feature to configure network addresses for DHCP, local IP address, local netmask,
local gateway, and local DNS server. The options are Disabled and Enabled.
Enable DHCP (Available when "Configured" is set to Enabled)
Select Enabled to support Dynamic Host Configuration Protocol (DHCP), which allows the
BIOS to search for a DHCP server attached to the network and request the next available IP
address for this computer. The options are Disabled and Enabled.
107
X14SAE/X14SAE-F: UEFI BIOS