Supermicro X14SAE - General Guidelines for Optimizing Memory Performance; DIMM Installation

General Guidelines for Optimizing Memory Performance
l
It is recommended to use DDR5 memory of the same type, size, and speed.
l
Mixed DIMM speeds can be installed. However, all DIMMs will run at the speed of the
slowest DIMM.
l
The motherboard will support an odd number amount of memory modules. However, to
achieve the best memory performance, a balanced memory population is
recommended.
l
When installing memory modules, the DIMM slots should be populated in the following
order: DIMMB2, DIMMA2, then DIMMB1, DIMMA1.
l
When installing only two memory modules, please use DIMMB2 and DIMMA2.
l
The motherboard will support odd-numbered modules (one or three modules installed).
l
However, to achieve the best memory performance, a balanced memory population is
recommended.
DIMM Installation
Important: Do not use excessive force when pressing the release tabs on the ends of the
DIMM socket to avoid causing any damage to the memory module or the DIMM socket.
Handle memory modules with care. Carefully follow all the instructions given in "Static-
Sensitive Devices" on page 33 to avoid ESD- related damages done to your memory
modules or components.
1. Insert the desired number of DIMMs into the memory slots based on the recommended
DIMM population table earlier in this section.
2. Push the release tab outwards to unlock the slot.
Figure 2-16. Unlock the DIMM Slot
45
X14SAE/X14SAE-F: Component Installation