HD Audio Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1–2 Enabled (Default)
Pins 2–3 Disabled
LAN Enable/Disable
Use JPL1/JPL2 to enable or disable LAN1/LAN2 on the X14SAE/X14SAE-F. The default
setting is Enabled.
LAN Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1–2 Enabled (Default)
Pins 2–3 Disabled
ME Manufacturing Mode
Close pins 2–3 of jumper JPME2 to bypass SPI flash security and force the system to operate
in the manufacturing mode, which will allow the user to flash the system firmware from a host
server for system setting modifications. Refer to the table below for jumper settings. The default
setting is Normal.
For a detailed diagram of the X14SAE/X14SAE-F motherboard, see the layout under "Quick
Reference" on page 13.
ME Manufacturing Mode
Jumper Settings
Jumper Setting Definition
Pins 1–2 Normal (Default)
Pins 2–3 Manufacturing Mode
Onboard TPM Enable/Disable
Use JPT1 to enable or disable the onboard TPM.
For a detailed diagram of the X14SAE/X14SAE-F motherboard, see the layout under "Quick
Reference" on page 13.
73
X14SAE/X14SAE-F: Component Installation
To Next Page
Loading...
